Category:
Gripper_Vacuum
Nihon PISCO
Product Feature
- Vacuum grippers suitable for transfer of large workpieces.
- The suction surface is made of sponge (Rectangular ring shaped). Suitable for a wide range of workpieces.
- Vacuum generator built-in type and vacuum pump compatible type are available.
- Vacuum generator built-in type secures max. suction flow rate: 760L/min(*)
* Value for 3 built-in ejectors specification.
Official product page
Specification
Purchase Information
Compatibility
Specification
Item | VRG | |||
Type | Sponge(Rectangular ring type) | |||
Code | 1515 | 2617 | 4730 | |
Suction surface size | 150 x 150 | 260 x 170 | 470 x 300 | |
No. of rows | – | – | – | |
Fluid medium | Air, vacuum(※1) | |||
Operating pressure range | Only for Vacuum Generator spec. | 0.3~0.7MPa | ||
Rated supply pressure | 0.5MPa | |||
Noise level | 70㏈(A) | |||
Operating vacuum pressure | Only for Vacuum Pump spec. | -100~0kPa | ||
Operating temp. range | 5~50℃(No freezing) | |||
Theoretical suction force(※2、3) | Safety factor 1/4(Horizontal lifting)(N) | 235.8 | 326.2 | 1512.7 |
Safety factor 1/8(Vertical lifting)(N) | 117.9 | 163.1 | 756.4 | |
Accessory | Robot flange mounting plate, Digital Pressure Sensor with 3-color dual display, Push-in fitting for air piping | |||
Spacer(included) | ||||
The stroke can be adjusted to suit the workpiece by changing the height of the adjusting plate on the inside of the pad. Four suction strokes in total: 10, 15, 20, and 25 mm (factory setting: 25 mm). Adjustable in 5 mm increments. * For VRG1515: 8, 13, 18, and 23 mm (factory setting: 23mm). |
*1 “Fluid medium: vacuum” is only for vacuum pump spec.
*2 Theoretical suction force at a vacuum of -80 kPa.
*3 Do not exceed the maximum load capacity of 100 kg of the main body mounting section, including the weight of the gripper body and inertia forces during transport.
Purchase Information
Compatibility
TM Model
Support All TM Model
HW
3.2 series, S series
SW
N/A